Jednak zanotowałem sobie w pliczku :-). Proszę bardzo:
Change ringtone/vibrate/LED flash characteristics:
If you would like more control over how your device rings/vibrates/flashes its LEDs on events, you can can change the Script values of these events. For example, for an incoming call performing 'activate device, play ringtone, wait 3 seconds, repeat':
HKCU\ControlPanel\Sounds\RingTone0\Script = "apw3r" (REG_SZ string, no quotes)
For performing 'active device, set volume to 33%, play ringtone, set volume to 67%, play ringtone, set volume to 100%, play ringtone (no repeat)':
HKCU\ControlPanel\Sounds\RingTone0\Script = "ac33pc67pc100p" (REG_SZ string, no quotes)
The following are the full codes available to you. Please note that all the codes are executed simultaneously except after a ringtone play / wait code. E.g. 'v1p' will vibrate and play at the same time, while vibrating for 1 second. But 'pv1' will play the ringtone through all the way first, then start vibrating for 1 second.
a = activate device
cN = set volume to N in percentage max volume
fN = flash notification LED for N seconds
p = play ringtone. Note that this will play the ringtone all the way through before continuing with the next code.
r = repeat. Note that this should be the last code in your Script string, if used at all.
vN = vibrate for N seconds
wN = wait for N seconds. Note that the device will wait this long before continuing with the next code.
Z tego wynika, że to opóźnienie może mieć taki scenariusz:
- przychodzi połączenie
- system próbuje zagrać dźwięk dzwonka ale sterownik dźwięku jeszcze nie odpowiedział po komunikacie wybudzenia i nie jest gotowy - dźwięk nie jest odtwarzany w rezultacie.
- 3 sekundy przerwy przed komendą "r" - powtarzaj
- ponownie odtwarzanie dźwięku ale sterownik jest już tym razem gotowy i wszystko gra